Ramming Speed 2: Signal Wiring

Receiver Signal Amplifier

Some radio control receivers require an inline signal amplifier to drive the Victor 883 controller. This is because the Victor was originally designed to be run by the IFI Robot Controller and although the signal interfaces are the same in format, most radio receivers cannot source enough current.

Description: Receiver Signal Booster
Vendor: Team Delta
Part Number: RCE600B

Connecting Wire

This is a Heavy Duty Futaba J-Series 400mm Servo Extension. This extension goes between the receiver and the speed controller. On one end of the wire is a male connector and on the other end of the wire is a female connector. Connectors slide snugly together to guard against vibrating loose. Gold-plated terminals improve conductivity and prevent oxidation for longer lifespan. Heavier, 20-gauge wire handles higher current loads with ease. Wire Gauge: 20 Length: 15-3/4″ (400mm) (between terminal ends)

Description: Futaba 400mm Heavy Duty Extension
Vendor: Tower Hobbies
Part Number: LXXA47

Posted: 02 March 4
Under: BattleBots
Viewed: 4 views